Grade of stainless steel, Type 316. Fully passivated after welding, to restore the original passive state of the 316 stainless steel.

LOCKING WASHER PLATE: Locks into position for easy tightening of nuts.
LUGS: MIG-welded to receiver bar and fully passivated after welding. Leading edge is rounded to prevent them from catching bolt bars during installation.
SHELL: 2B finish.
BOLTS: Thread-rolled for strength and coated to prevent galling. Bolts are MIG-welded to the receiver bar and fully passivated after welding.
NUTS/WASHERS: Type 316 stainless steel.
RECEIVER BARS: TIG-welded to shell to form a strong fusion, and fully passivated after welding.
GASKET: Natural rubber is specially formulated for water service incorporating antioxidant agents to increase shelf life. All gaskets have a gridded design, tapered ends and vulcanized armour plates for easy installation and optimum sealing efficiency. Nitrile rubber is available on request.
ARMOUR: Heavy gauge 316 stainless steel vulcanized into the gasket at the time of moulding.
TAPPINGS: Type 316 stainless steel, BSP parallel threaded socket.
FLANGES: Type 316 stainless steel, drilled to table ‘D’.
(Specifications are subject to change without notice).                         

General Information
Recommended pressure ratings:
(a) Clamps to suit pipes up to DN350mm nominal size - 1.6 MPa.*
(b) Clamps to suit pipes above DN375mm - 600mm nominal size -1.2 MPa.*

The amount of pressure that a full circle repair clamp will contain is proportionate to the diameter of the pipe being repaired and the amount of torque applied to the bolts. Smaller diameter repair clamps will contain more pressure than larger diameter repair clamps. Cleaning and lubricating bolt threads will reduce friction and permit greater torque.

1. The pressure containing capability of a repair clamp is influenced by the pipe size, the type and extent of damage to the pipe, environment and service conditions and installation workmanship.
2. Recommended Clamp lengths:
   The general recommendation is that the clamp length should be twice the pipe diameter. The clamp length should not be less than the diameter of the pipe.
   (a) In the case of longitudinal damage, we recommend a clamp length equal to 4 times the length of the damaged section of the pipe.
   (b) Where a large section of the pipe wall is broken away, a section of thin gauge sheet metal should be placed over the opening to provide a sealing surface for the gasket.
3. Stainless Steel Repair Clamps do not restrain axial pipe movement.

Suitable anchorage must be provided where pipe movement may occur.

* Pressure ratings may vary due to pipe condition and type. Refer to AS4181-1999 and WSAA Product Appraisal 03/15 for pipe types. Not recommended for PE pipes. Max. Temperature 55 degrees C.

E & OE